Pins on the bottom align with circuit board layouts

Check circuits through the clear cover while blocking out dirt and liquids

Release a spring instead of fussing with a screw to attach your wire

Ready to install without mounting the terminal block first

The ceramic body handles temperatures up to 1,200° F

Mix and match blocks to get the exact number of circuits you need

Cut power and swap out components on your circuit board without removing any wire

Snap wire into place with a clamp instead of fussing with a screw

Pull the plug to cut power and swap out equipment

Snap wire into place with a clamp instead of fussing with a screw

Handle as much voltage as other circuit board blocks while taking up half the space

Snap onto low-profile DIN 2 rail to save space in compact enclosures

Connect the same number of circuits as standard terminal blocks in a narrower footprint

Dividers separate live wires and keep your setup tidy

Rotate jumpers to match wye, delta, and other wiring layouts on motors

Connect thermocouple and RTD probes to wire and instrumentation

Connect thermocouple wire without distorting or destroying the signal

Snap wire in by hand to connect components on opposite sides of a panel

Mount in a panel cutout to connect components on opposite sides

Cut power with the pull of a plug while preventing shocks and short circuits

Recessed terminals protect you from shocks and prevent short circuits