Line up holes in sheet metal, I-beams, and angle irons for bolting, riveting, and welding
Add or remove links on belting
Place under material you're cutting or punching to protect work surfaces
Install fabric snaps and grommets
Create flares around holes in sheet metal to make the edges stronger and more rigid
Drive hole punches through thicker materials at a faster rate than you can with a wrench
Punch holes in metal, plastic, and fabric
Reach your hole saw into spots where your drill is too big to fit
Chip ice, start holes in thin metal and wood, and punch holes in leather and plastic
Set nails flush or drive them out of view without damaging wood surfaces
Strike with a hammer to loosen and remove pins and rivets
Protect your hands from accidental hammer strikes by gripping punches, stamps, and chisels
Alter roller chain length or strengthen it for better performance on high-speed drives
Push or twist to remove spring clips from links
Mark the center of an existing hole onto a separate workpiece
Filters
No Products Found
This category doesn't have any products yet.