Create a backside flange in hard materials and near edges in panels up to 0.312" thick

Mount flush against the outer panel's surface for low-clearance areas

Install with an arbor press into soft material, such as aluminum, at least 0.036" thick

Push the plunger to secure and pull to release for quick access

The domed top is decorative, plus the large surface spans wide holes

Press into the backside of a panel

Clip onto a thin panel to mount near edges

Press into a closed-end hole or thick panel

Ideal in thin panels for a flush fit

Snap into panels up to 0.125" thick—no tools required

A deeper drive than rounded head screws transmits more torque for a tighter hold

Ideal for frequent fastening and unfastening, turn by hand or with a slotted driver

An expanding rubber bushing dampens vibration while holding panels together

Press into the backside of a panel, then turn by hand

Clip onto a thin panel to mount near edges, then turn by hand

Press into a closed-end hole or thick panel, then turn by hand

Ideal in thin panels for a flush fit with wings you can turn by hand